EPE Range

Accumulators

  • Bladder accumulators liquid separator type ASL and trans

    Al l hydraulic accumulators are pressure vessels and are subject to the national regulations and directives, valid at the place of installation. Bladder accumulator type AS, up to and including 1litre, must not be CE marked.

  • Bladder accumulators low pressure type ASB

    Bladder low pressure type accumulators consist of a welded cylindrical pressure vessel made of steel . The accumulator is subdivided in to a gas and fluid side by an elastic bladder mounted in the interior of the vessel .

  • Bladder accumulators low pressureliquid separator type A

    valve is provided in the oil port of the bladder-type accumulator and closes when the pressure on the gas side is higher than the one on the fluid side. This prevents draining of the bladder into the oil channel and thus the bladder from being destroyed.

  • Bladder accumulators type AS and ASP

    phosphated or galvanized carbon steel in compl iance with Directive 2002/95/EC (RoHS) to resist to corrosion

Valves Back to Top

  • Blocks for relief valve type bpv and bapv

    These blocks are used for installation of safety valves type DBDS (see section 9.1) which must be ordered separately. The BPV type is built in sizes 6,10,20 and in the "G" versions with the threaded connections BSP ISO 228 or in the "P" version for mounting on plate.

  • fluid safety valves type dbds

  • Safety valves type VS

    The safety valves VS 224 are designed and manufactured by Epe Ita-liana. They have soft seal and total l i ft. They have a high flow coefficient (K = 0.95) and are sui table for gas and l iquids.

  • Shut off 2_way valves gas side

    The two-way ball valve is used to detect the safety valve type VS224 and to remove it for periodic recalibration, without having to fully di-scharge all the nitrogen of accumulator/accumulator station. The ball of the valve is located between two pre- compressed seals provided with a floating system, so it is guaranteed a perfect seal at both lowand high pressure .

  • Shut off 3_way valves gas side

    The three-way ball valve is used to detect the safety valve type VS224 and to remove it for periodic recalibration, without having to fully di-scharge all the nitrogen of accumulator/accumulator station. The ball of the valve is located between two pre- compressed seals provided with a floating system, so it is guaranteed a perfect seal at both lowand high pressure .

OUR
BRANDS